How do I force-end a stuck dive on a Divesoft Freedom computer?
If a Divesoft Freedom remains in dive mode on land, use the service menu's 'Force dive end' function, then check that firmware is current.
For unblocking a fictitious dive follow this procedure: press both buttons > release one of them > press it again > release both (see the video of this procedure here. Now you are in the service menu. Please select “Force dive end” item. All parameters of this “unwanted dive” will be erased (deco data and CNS included) and it doesn’t affect your next dive.
Check your Firmware version in Main menu > “System check” and make you sure that you have the latest. If not, please update it.
If your problems continue, go to the service menu again and select sensors. On the first page there are the pressure sensor values. Compare these values with expected atmospheric pressure (sensitive barometer, altimeter, local weather forecast etc.). If the pressure differs slightly (+/- 50 mbar) you can correct it in Setup>Calibration>Pressure corr.
If the values differ significantly or if they are changing significantly (keep in mind that the atmospheric pressure is changing permanently) there would be a sensor failure. If the sensor failure occurs, send it to our factory for repair.