Skip to content
English
  • There are no suggestions because the search field is empty.

SOLO connecting to PC display values on PC

 The analyzer can be connected to a computer using a USB cable.Measured values are transferred to the PC via a virtual serial port. If you have not installed a suitable driver for the virtual serial port on the USB, use the free driver provided by the manufacturer of the USB chip used in the analyzer. This driver can be downloaded from the Internet at http://www.ftdichip.com/Drivers/VCP.htm. The specific driver can be selected from the VCP (virtual com port) category, depending on the PC and operating system used. Use the instructions attached with the driver to install it.


Data transfer must be activated in the analyzer, set Menu/Preferences/Send Data to USB to a non-zero value


Any terminal emulation utility can be used for data reception; for instance HyperTerminal is sufficient for Microsoft Windows. This utility is included in the basic Windows installation.


The measured data are transferred in the text mode. Every second, the analyzer transmits data in the following format:
O2 ooo.o % Ti ttt.t ~C pppp.p hPa YYYY/MM/DD hh:mm:ssCRLeg. „ O2 21.1 % Ti 23.9 ~C 1004.1 hPa 2021/12/20 12:03:00CRLF“

Where:

ooo.o is oxygen content in percent,

ttt.t is temperature in Fahrenheit or Celsius,

pppp.p is barometric pressure,

YYYY/MM/DD hh:mm:ss is current date and time in 24h format,

CR is the ASCII carriage return symbol (decimal 13, hexadecimal 0D),

LF is the ASCII line feed symbol (decimal 10, hexadecimal 0A).


If there is an error in the measurement, the faulty entry is replaced with asterisks in the following form: **..


He/O2 only (auxiliary connector)The output is in serial form in the format 8N1 (8 bits, no parity bit, one stopbit), speed 115200 bit/s, TTL level.